Processor unit, PSJ-M2 gen.2, rear wire, GRIZZLY

The second generation of unique processing switching unit (PSJ) for AEG guns with gearbox version III. from GRIZZLY airsoft. Much easier installation and a large number of new features will bring even more fun than before.

Sorry, but this product is out of stock.
We could inform You about restocking.

57,96 € incl. VAT

The second generation of unique processing switching unit (PSJ) for AEG guns with gearbox version III. from GRIZZLY airsoft. Much easier installation and a large number of new features will bring even more fun than before. Of course, it remains possible to use even for powerful weapon with a powerful spring to M190. In a modified version retained all the functions and unique solutions proven first generation. Among the most important we can mention a completely contactless switching MOSFET cooled executive body of gearbox, active brake fully functional in all modes of shooting and fully adjustable short Burst. Additionally, the unit is equipped with indication of correct installation, a number of adjustable modes and many other useful features.

Benefits and features PSJ:
1) Shooting Modes (6 preset shooting modes, programming via trigger)
2) Rate of fire (allows you to adjust the delay between shots)
3) Special modes (restart, manual mode)
4) MOS-FET (unit contains no mechanical switch)
5) Active Brake (always ensure an immediate stop of the engine after the shot and completes the cycle)
6) Detection of error in the gearbox (when mechanical failure announce an error and prevent further damage)
7) Check against undercharging battery (Li-Polymer/Li-Ion/Li-Fe, for Ni-MH, Ni-Cd can turn this function off)
8) Realistic trigger travel (during installation, you can adjust the sensitivity/shutter)
9) Latch reverse is not the case of a powerful engine needed (although it is recommended to keep)
10) Everything is inside the gearbox (for simplicity, the unit is equipped with indication of correct installation)

Contents of the complete package:
• Processing unit PSJ-M2 Gen.2
• Complete wire according to the selected design
• 1pc insulating films and 1pc thermally foil
• detailed instructions for installation and use in the Czech language
• modified selector plate with magnet
• magnets to trigger and modified cut of
• Dean-T connector - male
• fast-on connectors for motor - 2pc
• thin for connectors

CAUTION: Installing PSJ-M2 always entrust experts at AEG guns. For damage caused by improper installation assumes no liability! Never use soldering iron!

Product Comments

So far no comments yet.

News and discounts